Average Rating

4.3 out of 5
 

Based on 14 reviews

43% would recommend this item to a friend.

0% Rated this
0% Rated this
 
 
 
 

18 out of 18 people found the following review helpful

3 out of 5

installation

 

You can get the sight in using the tool, but then cannot get the tool off the slide, as the sight is too wide at the back. You wouldn't know this unless you tried it yourself or found it in the FAQ - or both. It should be spelled out here and now it is.

 
 

2 out of 2 people found the following review helpful

3 out of 5

A must-have for target shooting

 

My stock 92FS was no pleasure to shoot, even in single action. I installed a factory Beretta rear target sight and the following Wilson Combat items: steel trigger, lowest power hammer spring, lowest power trigger return spring. For around $130, it's now a far better gun and my groups have shrunk in half with no more tendency down and to the left. Single action is really nice and crisp now.

Would you recommend this product to a friend? Yes
 
 

1 out of 1 people found the following review helpful

3 out of 5

Target sights for the 92FS/M9A1

 

I just ordered the sight, its in the mail. On my sight removal tool had to file down the base to it fit into the side. The removal tool worked fine on my PX4 but had it file it down to fit my M9Al slide. Plan on a little work when putting a new sight on your pistol. The fixed factory sight were a nightmare...hope these sight will do the job. You will need the sight removal tool to get the factory sight off, it was impossible to get my factory px4 sight off with out it. Wish me luck when I get the sight, can't wait to get it on and go shooting. Both the PX4 storm and the M9A1 function great, both are great pistols but you will need new sights, I know I did.

Would you recommend this product to a friend? Yes
 
 
3 out of 5

92/96 rear target site

 

Bought the adj rear site for my 92FS. My 92 always shot a little to the left. I can now center my shot pattern so I am very pleased. Installation was a little tricky. The factory rear site did not want to come out. I used a brass drift and a tack hammer to dismount the old site. It comes out right to left looking down the barrel as if shooting. I sanded off the paint on the new rear site dove tail assy just to make the install easier. Pressed the new site on with the brass drift and tack hammer. I used a bench vise with soft pine wooden strips taped in the jaws to hold the upper assembly. That way it did not scratch it. In all it took about 30 minutes. Very pleased with the results.

Would you recommend this product to a friend? Yes
 
 

Join Our Email List

Sign up to receive emails from Beretta for special sales, new product developments, and select Beretta news.

SIGN UP NOW