e00457
Click & Drag To Rotate
[+]
e00457
Click & Drag To Rotate
  • There are no alternate images available for this product.

Beretta PX4 Series, Adjustable Rear Sight & Front Sight

4.4 out of 5
read reviews
# E00457
$69.00

Adjustable Rear Sight & Front Sight for PX4 series. Two white dots. Key included.

Adjustable Rear Sight & Front Sight for PX4 series.

Three white dot system.
Fits on: PX4 Full Size & Special Duty.
Not suitable for the PX4 Sub Compact.

For the installation (removing the original rear sight) we suggest to use the tool code # UD6A0027
PX4 and 8000 rear sight tool
or have the installation performed by an Authorized Beretta Service Center, click here for find one.


Removing the original.


Assembling the substitute.


Average Rating

4.4 out of 5
 

Based on 7 reviews

0% would recommend this item to a friend.

0% Rated this
0% Rated this
 
 
 
 

4 out of 4 people found the following review helpful

5 out of 5

Works great.

 

These work just as they should. good elevation and windage adjustments. Side note: the dots on the rear sight are a little smaller than the fixed rear sight dots. This is not an issues but is something that I noticed. I had a friend who is a machinist install these for me, as I was unable to remove the old sights with a hammer and punch. I am quite satisfied with these sights. I have been looking for an adjustable sight for my Px4 for a long time and these work great! Highly recommended.

 
 

2 out of 2 people found the following review helpful

4 out of 5

Not bad

 

First thing the old sights are very hard to get out. You'll need the sight tool. Second when you put the new ones in again with the sight tool. You will need to remove the part that has the dots. There is a set screw to the right which is a windage screw. Take it all the way out. Be careful not to lose the spring. The sight tool will not come off without removing this piece as its too wide for the tool to get past. Third be careful with the front sight. You can take it out with the sight tool but putting the new one in you might want to tap it in cause the sight tool doesn't fit flush with it and it cocks going in. I broke mine! Tap it in until the sight is in the slot with the center all the way in then you can use the sight tool to press it the rest of the way in. I put my old front sight back in for now till I get a new one and it works fine with the old one. Now that I have done it once on my. 45 it will be easier when I do my 9mm. I am also hoping these sights fit a taurus 917 since that gun is way off and the sights aren't adjustable! Maybe before I put the set on my Px4 9mm I try them on my Taurus 9

 
 

Join Our Email List

Sign up to receive emails from Beretta for special sales, new product developments, and select Beretta news.

SIGN UP NOW