Average Rating

4.3 out of 5
 

Based on 11 reviews

55% would recommend this item to a friend.

0% Rated this
0% Rated this
0% Rated this
 
 
 
 

1 out of 1 people found the following review helpful

3 out of 5

Problem with target sight installation

 

I used this tool to exchange the original 92FS sight with the 92FS target sight. Removal of the original sight was easy. Initial installation of the new target sight was easy. However, removal of the assembled slide and target sight was not. I had to back off the sight to the left about 1/2 to remove the assembly and then finish the installation with a punch and light hammer. In the end it still made the install go OK.

 
 
3 out of 5

Moves the Sight OK but........

 

Tool was purchased to install a Beretta 92 / 96 Target Adjustable Rear Sight out-line style Stock No: C60428 on a 92FS. It removed the stock sight fine, it instslled the target sight fine but when it was time to remove the slide from the tool the space in the sight pusher was not wide enough to allow the sight to pass through. I had to remove about 3/8 inch of thread from the thread on the slide stud position the pusher to one side and remove the slide stud from its hole rotate the slide and get it out that way. The tool would probabally work fine for most sights but not the target sights.

Would you recommend this product to a friend? Yes
 
 
3 out of 5

Great Tool

 

The tool worked very well. I was a little disapointed to find after installing the new adjustable rear sight the slide would not come out of the tool because the sight was to wide. Was forced to push the sight about 1/2 way off to get the slide out. needed to use a hammer to compleate the install.

Would you recommend this product to a friend? Yes
 
 
3 out of 5

It works but very expensive.

 

I bought this to replace the sight on a Beretta 92F that only had the single dot at the bottom. It was tough to remove the sight but once it pops loose it comes out pretty easitly. You cannot remove the target sight as it is to wide. Do not use this to put a sight back in as it hits to much at the top and causes it to push in at the wrong angle. The sight is softer than the slide so it tears up the sight. The cost of this item is outrageous. Easily 50% over priced. The use is limited to guns it will fits. I bought it at Christmas and got 40% off and then for spending enough got another 50$ gift cirtificiate so it was basicallly 50% off or what retail should be. Beretta should sell the item with on1 base nut. Then sell the base nuts for the other guns. The only difference between the 92/96 and PX4/8000 is the screw piece at the bottom. ie the piece that locks the slide.

Would you recommend this product to a friend? Yes
 
 

Join Our Email List

Sign up to receive emails from Beretta for special sales, new product developments, and select Beretta news.

SIGN UP NOW