2 out of 2 people found the following review helpful
Does NOT fit PX4 Sub Compact.
Correct diameter, but is TOO LONG.
The pin slot IS in the correct position.
IF one was inclined to try and cut down to the suitable length, it might work, BUT... it's not that simple.
While the center hole depth is adequate,
IF CUT TO LENGTH, the INSIDE BEVEL, needed to center the hammer spring, would have to be RECREATED too. Otherwise, the hammer spring wouldn't seat properly, as designed.
While I am confident I would be able to 'make it work', I'll save this part for the full-sized PX4 I plan to buy.
I have yet to find the correct Part # for the Sub Compact.
Fabricating one with UHMD stock might work (this part doesn't appear to be over-molded around a steel core), but I wouldn't risk it considering what is at stake. If you are in an environment where you need to leash it to your person. IT CAN'T FAIL.
A D-I-Y leash loop seems to be a contradiction of common sense, in this case.
I'll keep looking for S/C
Would you recommend this product to a friend?
Was this review helpful?