Beretta 92/96 Series Hybrid Right Hand IWB Holster Reviews

Back to Beretta 92/96 Series Hybrid Right Hand IWB Holster

Average Rating

3.8 out of 5
 

Based on 16 reviews

81% would recommend this item to a friend.

 
 
Would you recommend this product to a friend?
 
 
D
3 out of 5

Hybrid Holster M9A1 Compact

 

I wear this holster often w either a 92 or railed compact. First thing I did was remove some material from the rear corner so that I could give my middle finger access for a better purchase. Holster is comfortable but the pistol does not snap in so the retention is slightly loose. The gun falls out when tipped upside down. It fits tighter when worn. A nut retaining one of the clips worked loose and was lost. So I replaced the screw and nut with a rivet and put loctite on the other one. I am considering replacing both the metal clips clips with leather snap loops because the forward clip shifted and scratched the top of my barrel during re-holstering while doing drills.

Would you recommend this product to a friend? No
 
 
b
3 out of 5

Close, but...

 

Does not accommodate the trigger guard of my 92 FS, OK for my 96A1 with the round trigger guard. But, the top edge of the polymer part is too tight and it marred the front edge of the right genuine Beretta wood grip on my 96A1. (The 92 FS didn't go in deep enough for this to happen.) I can probably fix both issues by heating the relevant areas with a heat gun and shoving my protected pistol into it while it's hot. But I shouldn't have to...Otherwise, it looks like a good holster for concealed carrying of these full-size pistols. I wish they made one like this for the 80 series.

Would you recommend this product to a friend? Yes