Beretta 92/96 Series Wood Grips Reviews

Back to Beretta 92/96 Series Wood Grips

Average Rating

4.7 out of 5
 

Based on 45 reviews

47% would recommend this item to a friend.

 
 
Would you recommend this product to a friend?
 
 
7

2 out of 3 people found the following review helpful

4 out of 5

Not bad at all.

 

Great product. Just received the order and the walnut is a beautiful touch to an already classy looking firearm. The only downside is the extra girth, which can make the already large size of the 96A1 feel a bit unwieldy in a single hand grip, especially for smaller hands. But this is easily rectified by utilizing a typical two hand grip, and the extra size will seem to dissipate felt recoil by a small amount. I would have given 5 stars except for the size increase. It may not be perfect, but it definetly looks awesome!

 
 
J

1 out of 2 people found the following review helpful

4 out of 5

Paler than expected

 

My set came much paler than shown in the photograph. However, on my stainless steel 92, it looks good. I have an early 90's 9mm that has all ss looking components from safety to mag base plate. I was also able to find ss hex screws from Hugoe. Too pale for blued 92.

Would you recommend this product to a friend? Yes
 
 
BE

1 out of 1 people found the following review helpful

4 out of 5

DON't over tighten!!!!

 

these grips are beautiful.. HOWEVER, they are thinner than stock grips. with the washers in place the screws are too tall. I took out the washers and the grips fit perfectly. with the washers in, there is a tendancy to over tighten to make the screws flush with the grips which leads to over tightening and a gunsmith bill..

Would you recommend this product to a friend? Yes
 
 
JE
4 out of 5

Plastic finish

 

Quality grips, fit great but the finish looks like plastic, not like what the picture shows.

Would you recommend this product to a friend? Yes
 
 
D
4 out of 5

Lighter Color Than Shown Here

 

Grips are fine, just lighter in color than the picture shown on this web site.

Would you recommend this product to a friend? Yes
 
 
R
4 out of 5

Careful with your original screws

 

These are absolutely gorgeous grips on my M9 .22 pistol. Fit is perfect. Problem I ran into was with the screws. These grips are wider than the black plastic original grips and as such the screws offered on the website are much shorter than the original screws and don't even pass all the way through these grips. Thus, I had to use the original screws which is not a problem except that those hex head screws will round out very easily and you must be extremely careful when removing them (requires 5/64 hex wrench). I did manage to round out one of my original screws but was able to use a torx head to remove it and then reinstall on the new grips. Thankfully, the torx didn't scratch up my original screw so the completed job is a fantastic looking pistol. However, I don't understand why the screws sold on the site aren't the same length as those that originally came with the gun. My concern is that should I change the grips in the future to a G-10, etc. then how can I get some of the screws

Would you recommend this product to a friend? Yes