OK, if you don't care about appearance and you are content to just stick something on there then this is fine. But if you want performance and also want it to look nice it is horrible. When you line up the logo holes on the left side, then wrap it around the grip as you would to install you will see the hole on the other side is halfway over the logo and the backstrap is not centered. If you center the backstrap, then both holes are offset over the logo by about 3/16 of an inch. If you line up both sides as it is intended, with the logos centered in the holes, the backstrap of this grip tape is an eighth to 3/16 away from touching the grip frame. Therefore it will not in any way fit as it is intended, at least not on the compact with the standard inserts that come on it when bought new. Do not think it will look like the picture here where it is all nice and trim and lined up.
Would you recommend this product to a friend?
Was this review helpful?